Hi All,
I have recently purchased a CV 1800 cyclone without filters, because I want to exhaust outside. The problem I face now is that the straight connector size does not match anything standard I can find. It is almost 9" OD in one direction and 8.5" OD in other direction (it is a slight ellipse, not circle). Inside diameters (ID) are similarly different, but slight smaller than OD. I tried 8" metal duct connectors, and it is too small for this size. It is supposed to go outside the straight connector, but I can easily put it inside with big gap on sides. 10" duct connectors are too large. Do you have any recommendations? I could purchase a short piece 8" flex hose (expensive and difficult to find), but I am afraid it won't fit over the straight connector.
I have recently purchased a CV 1800 cyclone without filters, because I want to exhaust outside. The problem I face now is that the straight connector size does not match anything standard I can find. It is almost 9" OD in one direction and 8.5" OD in other direction (it is a slight ellipse, not circle). Inside diameters (ID) are similarly different, but slight smaller than OD. I tried 8" metal duct connectors, and it is too small for this size. It is supposed to go outside the straight connector, but I can easily put it inside with big gap on sides. 10" duct connectors are too large. Do you have any recommendations? I could purchase a short piece 8" flex hose (expensive and difficult to find), but I am afraid it won't fit over the straight connector.