kinghong1970
New member
Hello,
i must have assembled and removed the impeller about 4 times so far... and still not sure if i've done them correctly.
i've placed the impeller along the shaft of the motor,
placed and aligned the taper lock on top of the impeller,
aligned to make sure the machine screws are inserted on the non-threaded holes of the taper lock and screwed onto the threaded holes on the impeller
inserted the key
and tightened the screws progressively and the impeller is lifting up against the taper lock.
now my question is...
1) does the impeller rest against the taper lock or is it ok to have a gap between the taper lock and the impeller?
2) how far from the edge/tip of the motor shaft should the taperlock be located?
can CV folks provide clearer images of the taper lock install process?
thanks in advance,
Al
i must have assembled and removed the impeller about 4 times so far... and still not sure if i've done them correctly.
i've placed the impeller along the shaft of the motor,
placed and aligned the taper lock on top of the impeller,
aligned to make sure the machine screws are inserted on the non-threaded holes of the taper lock and screwed onto the threaded holes on the impeller
inserted the key
and tightened the screws progressively and the impeller is lifting up against the taper lock.
now my question is...
1) does the impeller rest against the taper lock or is it ok to have a gap between the taper lock and the impeller?
2) how far from the edge/tip of the motor shaft should the taperlock be located?
can CV folks provide clearer images of the taper lock install process?
thanks in advance,
Al