Mike Goetzke
New member
I'm planning to replace my Jet DC1100 with a CV1800. I'm in a garage shop so like many space is limited/valuable.
Here is my DC1100 with ceiling mounter motor/blower to save space and duct runs. This is the left bay of my 2-1/2 car attached garage. Notice the ducting and where the suction side of the blower attaches to the ducting. Plus the false wall with the peg board was installed to block a direct view of my tools from the street (it makes a nice work area too). One of my sons had the idea to run that ducting on the top of the wall then is goes down where I have a 4" hose. I use this port mostly for my TS - the location makes for an easy/convenient hook up.
This is another shot of the wall - note the 4" port at the bottom left.
A view of my other ducting runs.
......continued
Here is my DC1100 with ceiling mounter motor/blower to save space and duct runs. This is the left bay of my 2-1/2 car attached garage. Notice the ducting and where the suction side of the blower attaches to the ducting. Plus the false wall with the peg board was installed to block a direct view of my tools from the street (it makes a nice work area too). One of my sons had the idea to run that ducting on the top of the wall then is goes down where I have a 4" hose. I use this port mostly for my TS - the location makes for an easy/convenient hook up.
This is another shot of the wall - note the 4" port at the bottom left.
A view of my other ducting runs.
......continued
Last edited: