tamathumper
New member
Aside from some discussion about stands, some build galleries and pictures, there's really no "stand plans" that I can find on the forum.
I'm trying to come up with the smallest footprint that I can for housing the cyclone, built entirely out of 2x4 lumber.
I put together the pictured plan yesterday in TinkerCAD, and I was wondering what everyone thought.
The interior dimensions are very close to the pictured dimensions of the unit from the instruction manual, except that it's 48" wide so the inlet will protrude out the left-hand side of the stand.
Overall, the dimensions are 8' tall, 48" wide (inside) and 24" deep (inside). The legs do impinge on the inner dimensions in the corners, but I don't think that's a problem.
Does anyone see a problem with these dimensions and this plan? If it's "forum approved" I'll share the plan on TinkerCAD (actually already done), and put up a cut list to help people use the minimum amount of lumber.
I'm trying to come up with the smallest footprint that I can for housing the cyclone, built entirely out of 2x4 lumber.
I put together the pictured plan yesterday in TinkerCAD, and I was wondering what everyone thought.
The interior dimensions are very close to the pictured dimensions of the unit from the instruction manual, except that it's 48" wide so the inlet will protrude out the left-hand side of the stand.
Overall, the dimensions are 8' tall, 48" wide (inside) and 24" deep (inside). The legs do impinge on the inner dimensions in the corners, but I don't think that's a problem.
Does anyone see a problem with these dimensions and this plan? If it's "forum approved" I'll share the plan on TinkerCAD (actually already done), and put up a cut list to help people use the minimum amount of lumber.