I don't know where I should put this question..........the moderator can move it if it's in the wrong forum.
I've had my clearvue for 3-4 yrs now with 0 problems. I have noticed there is considerable dust building up near the top of my cyclone. Plus it seems that I am not pulling dust from my tools like it did before.
Now my question..................what tool/meter do I use to check the air suction at my tools....................and what are the numbers I should have??? Is it in PSI or vacuum????
Oh ya........I have a 6" run of PVC from my cyclone along the wall with 4" drops to my tools. The 4" lines are from 5' to maybe 10' in length, with short lengths of spiral hose hooked to the tools.
Thanks,
gary
I've had my clearvue for 3-4 yrs now with 0 problems. I have noticed there is considerable dust building up near the top of my cyclone. Plus it seems that I am not pulling dust from my tools like it did before.
Now my question..................what tool/meter do I use to check the air suction at my tools....................and what are the numbers I should have??? Is it in PSI or vacuum????
Oh ya........I have a 6" run of PVC from my cyclone along the wall with 4" drops to my tools. The 4" lines are from 5' to maybe 10' in length, with short lengths of spiral hose hooked to the tools.
Thanks,
gary