Hello,
I have a 5 HP leeson motor that used to run a large 16" jointer. Id like to use it for my cyclone installation, but it has a 1" shaft I believe. My question is, can I buy a taper bushing with appropriate bore to fit the taper lock that comes installed on the 15" impeller? FYI I'm installing it on the CV1800.
I have a 5 HP leeson motor that used to run a large 16" jointer. Id like to use it for my cyclone installation, but it has a 1" shaft I believe. My question is, can I buy a taper bushing with appropriate bore to fit the taper lock that comes installed on the 15" impeller? FYI I'm installing it on the CV1800.