Hi Everyone,
These forums have been so helpful! I have a question about the dust collection for my Laguna Fusion table saw. The 4 inch port also has a small tube running to a blade shroud. I’m going to either increase the size of that port to a 5” or 6” port. Should I leave the shroud tube as is, or route it to the back of the saw body and hook a Fein Shop Vac up to a port I could install there? Also going to get a 4” SharkGuard. Is there a downside to this I am not seeing? Is it overkill?
Thanks,
Tim
These forums have been so helpful! I have a question about the dust collection for my Laguna Fusion table saw. The 4 inch port also has a small tube running to a blade shroud. I’m going to either increase the size of that port to a 5” or 6” port. Should I leave the shroud tube as is, or route it to the back of the saw body and hook a Fein Shop Vac up to a port I could install there? Also going to get a 4” SharkGuard. Is there a downside to this I am not seeing? Is it overkill?
Thanks,
Tim