Samurai Dave
New member
All of the designs I have seen so far show the dust collection bin directly under the cyclone.
Does the inlet need to be dead center on the lid of the collection bin, or can it be off-center?
How long can a connector tube be from the bottom of the cyclone to the collection bin?
Could this connector tube be a 90 degree smooth sweep (not a sharp 90) elbow instead of a straight tube? Allowing the cyclone to remain upright, but discharging into the side of the collection bin.
Thank you in advance for sharing your experiences.
Does the inlet need to be dead center on the lid of the collection bin, or can it be off-center?
How long can a connector tube be from the bottom of the cyclone to the collection bin?
Could this connector tube be a 90 degree smooth sweep (not a sharp 90) elbow instead of a straight tube? Allowing the cyclone to remain upright, but discharging into the side of the collection bin.
Thank you in advance for sharing your experiences.