R
Rex
Guest
Ok, Here goes a multi=part session on a shop planned in a house new to us. We expect to start moving by the end of next week (April 15). The new shop is the third car slot in a three car garage. It will be 330 sq ft in area (12' X 26' 10"). As our prioriities are to get us settled into a liveable condition first, the shop is lower on the priority list, so it may be at least a month before I get into the actual shop setup including the new cyclone (expect it to arrive this next week - thanks to Ed and his son). However, I am a planner, and so I would like to share the shop layout and a proposed overhead ducting diagram and get some feed-back from Ed and others in the forum before I actually get into setting up the shop and ClearVue.
I have two drawings to share. the first is the shop layout with benches, tools, and wood storage. The second overlays that with the ClearVue placed just outside the garage-to-shop door and a proposed ducting system. Note I have added an air return (thanks Ed). I have ordered six blast gates and only show four installed. Note that I show all the tools along the walls. Normally I will roll a tool, e.g., the table saw into the center of the shop placing it as I want including setting it for a rip operation with the outfeed going over the cabinetmakers bench. I've noted all the tools that are on wheels. I plan to have drops from the overhead ducting to connect to the tool(s) in use. I am concerned that I will have two many drops open on some gate close/open combinations and so will appreciate constructive feedback.
Now all I have to do is figure out how to get an image into the file or attach a file. I see there is an earlier message from ed that attaching files are possible, but I haven't figured it out. Help!
Thanks in advance,
Rex
I have two drawings to share. the first is the shop layout with benches, tools, and wood storage. The second overlays that with the ClearVue placed just outside the garage-to-shop door and a proposed ducting system. Note I have added an air return (thanks Ed). I have ordered six blast gates and only show four installed. Note that I show all the tools along the walls. Normally I will roll a tool, e.g., the table saw into the center of the shop placing it as I want including setting it for a rip operation with the outfeed going over the cabinetmakers bench. I've noted all the tools that are on wheels. I plan to have drops from the overhead ducting to connect to the tool(s) in use. I am concerned that I will have two many drops open on some gate close/open combinations and so will appreciate constructive feedback.
Now all I have to do is figure out how to get an image into the file or attach a file. I see there is an earlier message from ed that attaching files are possible, but I haven't figured it out. Help!
Thanks in advance,
Rex