I installed a Clear Vue, 5HP unit about 9 months ago. The blower is installed as recommended by CV. The motor receives good air flow around it and is protected with a 240V, 30A dedicated circuit. The duct work at the input and the output of the blower is clear. Just today the blower starts up slowly, runs for about 3 seconds and then trips the circuit breaker. I have tried it a number of times with the same results. The motor is not over heating. I opened the input and output duct work with the same results. I have not removed the motor yet so I have been unable to check for binding or the condition of the bearing, but a visual check does not show any problem.
Has anyone had this problem? If so, what did you find? Any ideas?
Thanks,
Fred Sotcher
408-253-7831
fsotcher@gmail.com
Has anyone had this problem? If so, what did you find? Any ideas?
Thanks,
Fred Sotcher
408-253-7831
fsotcher@gmail.com