Wiring the coil and remote start feature

M

martys

New member
I purchased a package deal from Ed which came with the 110v remote control and a coil. When I installed the unit I didn't think I would want the remote start capability so I simply wired it through a wall switch. I've changed my mind now and want to use the remote. I find that the wiring instructions in the installation manual are confusing. The coil didn't come with any terminal markings or instructions. Can someone please post a physical wiring diagram, a picture or a link to instructions that show how wire it properly? I currently have 220v three wire running to the motor.

Thanks

Marty
 
Marty,
The wiring diagram is on the website in the installation instructions. Basically, the remote that we sell plugs into a 110V outlet. And, it has it's own 110 V receptical that it switches on and off. So, you simply need to plug the remote into an outlet and then plug the coil of the relay into the receptical on the remote control. It will switch the relay on and off just like a light switch. Hope this helps.

Ed
 
You must log in or register to reply here.
Back
Top