hiya all, just joined up here after finding the thread for the diy fill sensor
i have a CV max- going into a 55gal drum, and we fill a drum in a day and a half.
i like the setup here.
went on amazon- the links didnt work, but the part no produced a bunch of hits- not sure which board was the right one.
any help would be greatly appreciated.
i am a bit of a techno peasant, so any help or directions with this project would be greatly appreciated
second question, is would i be able to use a similar setup in the pvc pipe right at our milling machine- sometimes if the wood is milled off in a big spiral, it can plug the pipe right close to the machine- the pipe is 6" right before it goes into the 8" i could cut holes in the pvc and super glue clear lexan over the pipe to create little windows to put this equipment up against.
this is an auto fed machine- so there are not always "eyes on " the machine
many thanks all!!
Ps- i am in Canada