This is a good example of what can be made. I cut both parts close then heated the big pipe and shoved the 4" in from the inside. Then glued it with PVC glue.
Sorry that last was 6' on both sides. Here was a fun Y. Icut both of the 4" on an angle then epoxied them together. i cut this assembly then heated the 6" bent it around the double 4". A little glue and its ready to use.
I will post the rest when I finish.
I did the cutting and bending to fit difficult areas and just to see if I could. It is very time consuming so I don't think Iwould try and make all the Y's ,90s etc.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.